Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

102 DCFM Enterprise User Manual
53-1001357-01
End node display
3
End node display
The connectivity map can be configured to display or not display end nodes. This option enables
you to set the end node display for all newly discovered fabrics. Note that disabling end node
display limits the connectivity map to emphasize switch members only.
Displaying end nodes
To display end nodes when discovering a new fabric, complete the following steps.
1. Select SAN > Options.
The Options dialog box displays (Figure 36).
FIGURE 36 Options Dialog Box (End Node Display option)
2. Select End Node Display in the Category list.
3. Select the Show connected end nodes when new fabric is discovered check box to display end
nodes on your system.
NOTE
Before changes can take effect, the topology must be rediscovered.
4. Click Apply or OK to save your work.