Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 111
53-1001357-01
Viewing names
3
5. Click OK to close the Configure Names dialog box.
6. Click OK on the confirmation message.
Viewing names
To view names associated with devices by name, complete the following steps.
1. Select Configure > Names.
The Configure Names dialog box displays.
2. Select All Names from the Display list.
Only devices with a name display. The table displays the Name, WWN, Operational Status,
Type, and a Description of the device.
3. Click OK to close the Configure Names dialog box.
Adding a name to an existing device
To add a name to an existing device, complete the following steps.
1. Select Configure > Names.
The Configure Names dialog box displays.
2. Select how you want to display devices from the Display list.
You can display devices by All Names, All WWNs, Only Fabrics, Only Products, Only Ports, or
Switch and N Ports.
All discovered devices display.
3. Select the device to which you want to assign a name in the Display table.
4. Double-click in the Name column for the selected device and enter a name for the device.
If you set names to be unique on the Options dialog box and the name you entered already
exists, the entry is not accepted.
NOTE
If you segment a fabric, the Fabric’s name follows the assigned principal switch.
5. Click OK on the confirmation message.
6. Click OK to close the Configure Names dialog box.