Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 285
53-1001357-01
Setting up advanced event filtering
7
8. Select one of the following options:
• Select Send to and enter an e-mail address for a user to send a test e-mail to a specific
user.
• Select Send to all users enabled for notification to send a test e-mail to all users already
set to receive notification.
9. Click Send Test E-mail to test the e-mail server.
A message displays whether the server was found. If the server was not found, verify that the
server address was entered correctly and that the server is running. If you are using an SMTP
mail server, also verify that the SMTP ID and password information was entered correctly.
10. Click OK to save your work and close the E-mail Event Notification Setup dialog box.
Setting up advanced event filtering
To set up advanced event filtering on the selected events for a user, complete the following steps.
1. Select SAN > Users.
The Server Users dialog box displays.
2. Select a user in the Users table and click Edit.
The Edit User dialog box displays.
3. Select the E-mail Notification Enable check box and click the Filter link.
The Define Filter dialog box displays.
4. Click Advanced Filtering.
The Advanced Event Filtering dialog box displays.
5. Click the Include Events tab.
FIGURE 108 Advanced Event Filtering Dialog Box - Include Events tab
a. Select the event type you want to include from the Event Type list.
All event types are listed in alphabetical order.