Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

290 DCFM Enterprise User Manual
53-1001357-01
Editing a destination
7
Editing a destination
To edit a destination, complete the following steps.
1. Select Monitor > SNMP Setup.
The SNMP Setup dialog box displays.
2. Click the Trap Forwarding tab.
3. Select the destination you want to edit in the Destinations table and click Edit.
The Add/Edit Trap Recipient dialog box displays.
a. (Optional) In the Description field, edit the description of the trap recipient.
b. In the IP Address field, edit the trap recipient’s IP address.
The Management application accepts IP addresses in IPv4 or IPv6 formats.
c. Edit the trap recipient’s UDP port number, in the port field.
d. Click OK on the Add/Edit Trap Recipient dialog box.
4. Click OK on the SNMP Setup dialog box.
Removing a destination
To remove a destination, complete the following steps.
1. Select Monitor > SNMP Setup.
The SNMP Setup dialog box displays.
2. Click the Trap Forwarding tab.
3. Select the destination you want to remove in the Destinations table and click Remove.
Press Ctrl and then click to select more than one destination.
4. Click OK on the SNMP Setup dialog box.
Disabling trap forwarding
You can disable trap forwarding on all defined destinations.
To disable trap forwarding, complete the following steps.
1. Select Monitor > SNMP Setup.
The SNMP Setup dialog box displays.
2. Click the Trap Forwarding tab.
3. Clear the Enable trap forwarding check box.
4. Click OK on the SNMP Setup dialog box.