Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 319
53-1001357-01
Configuring an F_port mode Top Talker monitor
8
FIGURE 119 Top Talkers dialog box
3. Click Select.
The Top talker Selector dialog box displays.
4. Select F Port to select the F_port to monitor in the Top Talker Mode list.
You can only select one F_port on which to enable the Top Talker monitor.
5. Click OK on the Top talker Selector dialog box.
Top Talker is enabled on the selected port.
6. Select the number of Top Talkers (1 through 20) to display from the Display list.
7. Select how often you want the Top Talker to refresh (10, 20, 30, 40, or 50 seconds, or 1
minute) from the Refresh Interval list.
8. Select whether you want to monitor the receive (Rx) flow or the transmit (Tx) flow for the port
from the Flow list.
9. Click Apply.
The top 20 conversations display in the Current Top Talkers table. The Top Talkers Summary
table displays all Top Talkers that occurred since the Top Talkers dialog box was opened
(displays a maximum of 360). When the maximum is reached, the oldest Top Talker drops as a
new one occurs.
The F_port mode Top Talker provides the following details:
10. Click the minimize button to hide this dialog box when it is not needed.
• Rx Ave (MB/sec) or Tx Ave (MB/sec) • Last Occurred
• Occurrences • SID
• Source Name • Source Switch/Port
• DID • Destination Name
• Destination Switch/Port • Port Speed
• % Utilization •