Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

404 DCFM Enterprise User Manual
53-1001357-01
Link aggregation groups
13
3. Click Add LAG.
The Add LAG dialog box displays.
FIGURE 152 Add LAG dialog box
4. Configure the following LAG parameters:
NOTE
A LAG restriction exists whereby you can add 802.1x-enabled ports to a LAG, but the port will
fail when the LAG is saved to the switch. 802.1x-enabled ports are not supported.
• Status - Enabled or Disabled. You must enable the LAG to use the CEE functionality.
• Name - The system-generated, read-only LAG name.
• LAG ID - Enter the LAG identifier, using a value between 1-63. Duplicate LAG IDs are not
allowed.
• Interface Mode - L2 or None. Ports that are in L2 mode can’t be added to a LAG.
• L2 Mode - Select the L2 mode (Access or Trunk).
5. Select at least one available CEE port from the Available Members table and click the right
arrow button to move them to the LAG Members table.
The CEE ports are now part of the link aggregation group.