Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 407

53-1001357-01

Editing a CEE port

1. Select Configure > CEE Switch > CEE from the menu bar.

The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and

functions.

2. Select a CEE port from the Products/Ports table.

3. Click Edit.

The Edit Port dialog box displays.

FIGURE 154 Edit Port dialog box

4. Modify the following CEE Port parameters as required:

• Status - Enable or Disable. You must enable the LAG to use the CEE functionality.

• Interface Mode - None or L2.

• L2 Mode - This is enabled if you select L2 as the Interface Mode. You cannot change the

Interface Mode to None if it is set to L2 and the port is assigned to a VLAN.

5. When you have finished configuring the policies, apply the settings to the CEE port.

6. Click OK when you have finished modifying the CEE port parameters.

The CEE Confirmation and Status dialog box displays.

7. Review the changes carefully before you accept them.

8. Click Start to apply the changes, or click Close to abort the operation.