Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

426 DCFM Enterprise User Manual
53-1001357-01
Assigning an LLDP profile to a port or ports in a LAG
13
Assigning an LLDP profile to a port or ports in a LAG
You create LLDP profiles using the Edit Switch dialog box, which you access from the CEE
Configuration dialog box. Global configuration parameters, which is the default selection, are
displayed in the Assigned Profile table shown in Figure 163.
NOTE
When LLDP is disabled on the switch, a yellow banner displays on the LLDP-DCBX dialog box,
indicating that LLDP-DCBX is not only disabled on the switch, it is also disabled for all ports and LAGs
on the switch.
1. Select Configure > CEE Switch > CEE from the menu bar.
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
2. Select a port or link aggregation group (LAG), and click Edit.
3. Click the LLDP-DCBX tab on the Edit Port/Edit LAG dialog box.
The Assign an LLDP profile to <port name> dialog box displays.
FIGURE 163 Assign an LLDP profile dialog box
4. Click Assign an LLDP profile to <port name> button to enable the feature.
NOTE
Assign the Global Configuration is the default. The Available Profiles list is disabled if global
configuration is selected. In addition, the Assign an LLDP profile button is disabled if no LLDP
profiles exist on the switch.
5. Select an LLDP profile from the Available Profiles list.