Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

428 DCFM Enterprise User Manual

53-1001357-01

Adding an ACL to a switch

FIGURE 164 Access Control List dialog box

4. Click Add and select Standard or Extended from the Add list.

The Add Extended Access Control List includes all the Standard ACL features plus two

additional features: Destination and Ether Type. The ACL parameters are described below.

FIGURE 165 Add Extended Access Control List dialog box

5. Configure the following Access Control List parameters.

NOTE

You cannot duplicate Action and Source parameters in an existing Standard ACL. You cannot

duplicate Action, Source, Destination, and Ether Type parameters in an existing Extended ACL.

• Sequence - The sequence number that tracks all the ACL entities defined globally in the

system. If you assign a Sequence number that is the same as an existing ACL Entity, an

overwrite warning displays. After the overwrite operation, the system again checks for

duplicates, then it creates the new ACL entity.