Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

486 DCFM Enterprise User Manual
53-1001357-01
Tape Pools tab
16
Adding tape pools
A tape pool can be identified by either a name or a number, but not both. Tape pool names and
numbers must be unique within the encryption group. When a new encryption group is created, any
existing tape pools in the switch are removed and must be added.
1. Select Configure > Encryption from the menu bar.
The Encryption Center dialog box displays.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
bar.
The encryption groups display in the Encryption Devices table.
3. Select an encryption group from the tree, and select Group > Tape Pools from the menu bar, or
right-click the encryption group and select Tapepools.
The Add Tape Pool dialog box displays. The Name tape pool label type is the default; however,
you can change the tape pool label type to its number by selecting Number, shown in
Figure 194.
FIGURE 193 Add Tape Pool by name dialog box
FIGURE 194 Add Tape Pool by number dialog box
4. Specify the Tape Pool Label Type. Tape pools can be identified by either a name or a number,
shown in Figure 193 and Figure 194.
5. Enter a name for the tape pool. If you selected Number as the Tape Pool Label Type, the name
must match the tape pool label or tape ID/number that is configured on the tape
backup/restore application.