Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

506 DCFM Enterprise User Manual
53-1001357-01
Adding encryption targets
16
6. Select the encryption engine (blade or switch) you want to configure, and click Next.
The Select Target panel displays. This panel lists all target ports and target nodes in the same
fabric as the encryption engine. The Select Target list does not show targets that are already
configured in an encryption group.
There are two available methods for selecting targets: select from the list of known targets or
manually enter the port and node WWNs.
FIGURE 214 Select Target dialog box
a. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
the target information that displays using the nsshow command.) You can also enter
WWNs manually if you prefer, or if you want to specify a target that is not on the list.
b. Select a Target Type. Disk is selected and cannot be changed. If the target node is disk
storage, choose Disk. If the target port is tape storage, choose Tape.