Manualshelf

Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

ManualsBrandsHP ManualsSoftwareHP B-series Data Center Fabric Manager Enterprise Software
591592593594595596597598599600
560 DCFM Enterprise User Manual
53-1001357-01
Viewing zone configuration properties
18
5. Enter a name for the zone configuration.
For zone name requirements and limitations, refer to “Zoning naming conventions” on
page 547.
6. Press Enter.
Depending on the characters included in the name you enter, a message may display informing
you the name contains characters that are not accepted by some switch vendors, and asking
whether you want to proceed. Click Yes to continue, or No to cancel the zone creation.
7. Add zones to the zone configuration.
For step-by-step instructions, refer to “Adding zones to zone configurations” on page 561.
8. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
Viewing zone configuration properties
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Potential Members list.
This identifies the target entity for all subsequent zoning actions and displays the zoning library
for the selected entity.
4. Right-click the zone configuration you want to review in the Zone Configs list and select
Properties.
The Zone Config Properties dialog box displays.
5. Review the zone configuration properties.
The following information is included in the zone properties:
• Zone Config Name—The name of the selected zone configuration.
• Number of Zones—The number of zones in the selected zone configuration.
• Total Zone Members—The total number of zone members in the selected zone
configuration.
• Unique Zone Members—The total number of zone members that are unique in the zone
configuration.
• Status—The status of the selected zone configuration (active or not active).
6. Click OK to close the Zone Config Properties dialog box.