Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

600 DCFM Enterprise User Manual
53-1001357-01
Troubleshooting device connectivity
19
3. Click OK.
The following diagnostic tests are performed:
• Device Status
• Switch port health status
• Zone configuration in the fabric
• LSAN zone configuration in edge fabrics
• Edge fabric - FC router physical connection status.
• Active ACL DCC policy check (Fabric OS only)
The Device Connectivity Troubleshooting Results dialog box displays.
If no problems are found, the diagnostic test is marked with a check mark. If problems are
found, an alert icon appears next to the test, with a brief statement detailing the error as well
as a suggested resolution.
4. Click Re-run Diagnosis to run the device connectivity on the same ports.
5. Click Trace Route to trace the route between the two selected ports.
6. Click Close on the Device Connectivity Troubleshooting Results dialog box.
Adding detached device
To add a detached device to the Selected Device Ports table, complete the following steps.
1. Click Add Detached from the Device Connectivity Troubleshooting dialog box.
2. Add the detached device port by choosing one of the following:
• To add by port WWN, select the By Port WWN option.
• To add by FC address, select the By FC Address option.
3. Enter the port WWN or FC address in the field.
4. Click OK.