Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 47
53-1001357-01
Importing Hosts from a Fabric
2
6. Verify the imported values in the Host List text box.
7. Configure Host credentials, if necessary.
To configure host credentials, refer to “Configuring Brocade HBA credentials” on page 48 or
“Configuring virtual machine credentials” on page 49.
8. Click OK on the Add Host Discovery dialog box.
If an error occurs, a message displays. Click OK to close the error message and fix the problem.
A Host Group displays in Discovered Addresses table with pending status. To update the status
from pending you must close and reopen the Discover Setup dialog box.
9. Click Close on the Discover Setup dialog box.
Importing Hosts from a Fabric
To discover a Host from a discovered fabric, complete the following steps.
1. Select Discover > Setup.
The Discover Setup dialog box displays.
2. Click Add Host.
The Add Host Discovery dialog box displays.
FIGURE 15 Add Host Discovery dialog box - Host tab
3. Enter a discovery request name (such as, MyFabric) in the Name field.
4. Select Hosts in Fabric from the list.
5. Select All fabrics or an individual fabric from the list.
6. Click Add.
All hosts which are part of a managed fabric and have a registered host name display in the
text box. If no host with a registered host name exists, an error message displays. Click OK to
close the error message.