DCFM Migration Guide v6.4.0 (53-1001776-01, June 2010)

DCFM Migration Guide 31 of 38
53-1001776-01
Enterprise migration
2. Choose one of the following options:
• If data is detected on your system, one of the following screens display:
 A message displays. Click Yes on the message and click Next on the Partial Data Migration screen. Go
to step 5.
 The Copy Data and Settings screen displays. To migrate data from the previous version installed
(automatically detected), select Yes, from DCFM in the following location. Continue with step 3.
• If data is not detected, the Copy Data and Settings screen displays. Complete the following steps.
a. Select Yes, from DCFM installed in this machine or on network and click Browse to browse to the
installation directory.
b. Click Next on the Copy Data and Settings screen. Continue with step 3.
An error message displays if any of the following occur:
3. Click Start on the Data Migration screen.
Data migration may take up to 30 minutes.
4. Click Next on the Data Migration screen.
If you are migrating from Enterprise full edition, the Server License screen displays with the migrated source
license. Click Next on the Server License screen and go to step 6.
5. Choose one of the following options:
• If you are migrating to a licensed edition, enter the license key (on the Key Certificate) on the Server License
screen or browse to the license file (.xml) and click Next.
The License Key field is not case-sensitive.
• If you are migrating to a trial edition, click Next on the Server License screen.
If data was detected on your system in step 2, the Start Server screen displays. Go to step 12.
If data was not detected on your system in step 2, the FTP Server screen displays. Continue with step 6.
6. Select Internal FTP Server or External FTP Server on the FTP Server screen and click Next.
The default selection reflects the previous edition configuration.
If port 21 is busy, a message displays. Click OK to close the message and continue. Once the Management
application is configured make sure port 21 is free and restart the Server to start the FTP service.
NOTE
If you select to use an FTP Server which is not configured on the same machine as DCFM, the Firmware
Repository feature will not be available.
Error Fix
Selected location is not valid or not supported. Browse to the correct location of the application.
Upgrade to a supported version.