HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

Configuring the FS8-18 blade
For information on configuring the encryption functions, see the Fabric OS Encryption Administrator's
Guide.
Cabling the FS8-18 blade
To cable the FS8-18 blade:
1. Install the SFP transceivers in the FC and GbE ports, as required:
a. Remove the rubber plugs from the ports to be used.
b. Position the transceiver so that it is oriented correctly and insert it into a port until it is
firmly seated and the latching mechanism clicks.
For instructions specific to the type of transceiver, see the transceiver manufacturer's
documentation.
NOTE: The transceivers are keyed to ensure correct orientation. If the transceiver does
not install easily, ensure that it is correctly oriented.
c. Repeat step 1a and step 1b for the remaining ports, as required.
2. Connect the cables to the transceivers.
CAUTION: A 50-micron cable should not be bent to a radius less than 2 inches under full
tensile load and 1.2 inches with no tensile load. Do not use tie wraps to secure optical cables
because they are easily overtightened.
a. Orient a cable connector so that the key (the ridge on one side of connector) aligns with
the slot in the transceiver. Then, insert the cable into the transceiver until the latching
mechanism clicks. For instructions specific to cable type, see the cable manufacturer's
documentation.
b. Repeat step 2a for the remaining cables as required.
3. Observe the LEDs to verify that all components are functional.
4. Log in as admin.
5. Verify the correct operation of the FS8-18 blade ports by entering the switchShow command
from the Director command prompt. This command provides information about switch and
port status.
Recommendations for cable management
Manage cables as follows:
• Plan cable management before installing the blade.
• Leave at least one meter of slack for each port cable. This provides room to remove and
replace the blades, and helps prevent the cables from being bent to less than the minimum
bend radius.
112 Intelligent blades