HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

5. Fasten the port side of the chassis to the cabinet rails. Use three 10-32 x 5/8 in (1.58 cm)
screws (Item C) per rail. Tighten the screws to a torque of 37 cm-kgs (32 in-lb).
NOTE: Do not use the top or bottom holes of the DC SAN Director mounting bracket because
the door will interfere with the screw heads.
Figure 6 Positioning the DC SAN Director for installation in a cabinet
2. Air-intake side of chassis1. Rack cabinet (shown without sheet metal)
Figure 7 Attaching port side of chassis to rack rails
24 DC SAN Director installation