HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

Replacing the chassis door
You must install the chassis door to ensure the DC Director meets EMI and other regulatory
certifications. Additionally, if you do not use ICL cables, you must insert EMI plugs in the ICL cable
ports to meet certification standards.
NOTE: The door is not hinged. It installs on the chassis by snapping the four ball studs located
on the chassis into the receiving hardware on the door.
To replace the chassis door:
1. Align the eight ball studs on the chassis with mounting hardware locations on the chassis door
while pushing the door straight into the chassis.
2. Snap the door into place over the ball studs (see Figure 8 (page 26) and Figure 9 (page 26)).
Installing the DC SAN Director in the 14U Rack Mount Kit 25