HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

Figure 8 Aligning the DC SAN Director door with the chassis
Figure 9 Inserting DC SAN Director door on chassis ball studs
3. Ball stud on chassis (inside view of door)1. Ball stud on chassis (outside view of door)
2. Mounting hardware
Powering on the DC SAN Director
CAUTION: Use the supplied power cords. Ensure the facility power receptacle is the correct type,
supplies the required voltage, and is properly grounded.
To power on the DC SAN Director:
1. Connect the AC power cords to the power supply assemblies. One to four power cords are
required depending on electrical service.
26 DC SAN Director installation