HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

tip /dev/ttyb -9600
When the terminal emulator application stops reporting information, press Enter.
The following login prompt appears:
CP0 Console Login:
6. Log in to the DC SAN Director as admin. The default password is password. At the initial
login, the user is prompted to enter new admin and user passwords. Be sure to write down
the new passwords and keep this information in a secure location.
Fabric OS (swDir)
swDir login: admin
Password:
Please change your passwords now.
Use Control-C to exit or press 'Enter' key to proceed.
Password was not changed. Will prompt again at next login
until password is changed.
swDir:admin>
7. Modify passwords (optional step).
Passwords can be 8 to 40 characters long. They must begin with an alphabetic character.
They can include numeric characters, a period (.), or an underscore (_). Passwords are
case-sensitive, and they are not displayed when you enter them on the command line. To skip
modifying the password, press Ctrl+C. For more information on passwords, see the Fabric OS
Administrator's Guides.
Configuring IP addresses
The DC SAN Director requires three IP addresses, which are configured using the ipAddrSet
command. IP addresses are required for both CP blades (CP0 and CP1) and for the single logical
switch (shown as SWITCH under the ipAddrShow command) in the DC SAN Director.
Default IP addresses and password
The default IP addresses and host names for the DC SAN Director are:
• 10.77.77.75 / CP0 (the CP blade in slot 6 at the time of configuration)
• 10.77.77.74 / CP1 (the CP blade in slot 7 at the time of configuration)
The default password is password.
IMPORTANT: Resetting an IP address while the DC SAN Director has active IP traffic, such as
Fabric Manager, Fabric Watch, SNMP, or other applications, can cause traffic to be interrupted
or stopped.
To configure the IP addresses for both CP blades (from the active CP blade):
1. Log in to the active CP as admin using the serial cable connection.
2. Set up the DC SAN Director IP address by entering the ipaddrset -sw 0 command:
swDir:admin> ipAddrSet -sw 0
Enter the information at the prompts. Specify the -sw 0 IP address. There is no -sw 1 IP
address.
NOTE: The addresses 10.0.0.0 through 10.0.0.255 are reserved and used internally by
the DC SAN Director. External IPs must not use these addresses.
3. Set up the CP0 IP address by entering the ipaddrset -cp 0 command:
swDir:admin> ipAddrSet -cp 0
Enter the information at the prompts.
38 DC SAN Director login and configuration