HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

Replacing the cable management comb
The replacement procedure for the cable management comb takes less than five minutes and
requires a #1 Phillips screwdriver.
Removing a cable management comb
CAUTION: Wear a grounded ESD strap when handling DC SAN Director components. The
Director chassis provides a grounding connection above the power connectors. Also, store
ESD-sensitive components in antistatic packaging.
To remove the cable management comb:
1. Remove the chassis door. See Removing the chassis door (page 62).
2. Rearrange the cables around the cable management comb.
3. Remove and save the four screws holding the comb to the chassis (see Figure 33 (page 63)).
Support the comb to prevent it from falling.
4. Remove the cable management comb.
Installing a cable management comb
To install a cable management comb (see Figure 33 (page 63)):
1. Position and tighten the four screws to secure the cable management comb to the chassis.
2. Arrange the cables along the cable management comb.
Figure 33 Removing or replacing the cable management comb
Replacing the cable management comb 63