HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

switchWwn: 10:00:00:05:1e:39:59:67
zoning: OFF
switchBeacon: OFF
blade3 Beacon: OFF
blade5 Beacon: OFF
blade8 Beacon: OFF
blade10Beacon: OFF
Index Slot PortAddressMediaSpeedStateProto
===========================================================
32 3 00b2000idN4OnlineL-Port 5 public
33 3 10b2100__N8No_Module
34 3 20b2200__N8No_Module
35 3 30b2300__N8No_Module
36 3 40b2400idN4OnlineF-Port
10:00:00:00:c9:51:00:2d
37 3 50b2500__N8No_Module
rsl8-st03-dcx-1:admin>
4. Verify that all the IP address information is correct by entering the ipAddrShow command,
and compare the results to the IP information recorded in the config-miscinfo.txt file.
rsl8-st03-dcx-1:admin> ipaddrshow
SWITCH
Ethernet IP Address: 10.32.50.12
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
CP0
Ethernet IP Address: 10.32.50.10
Ethernet Subnetmask: 255.55.0.0
HostName : cp0
Gateway Address: 10.32.40.1
CP1
Ethernet IP Address: 10.32.50.11
Ethernet Subnetmask: 255.55.0.0
HostName : cp1
Gateway Address: 10.32.40.1
Backplane IP address of CP0 : 10.0.0.5
Backplane IP address of CP1 : 10.0.0.6
rsl8-st03-dcx-1:admin>rsl8-st03-dcx-1:admin>
Reconnecting to the network and the fabric
See the cable routing information that was recorded in Table 19 (page 94) for the following steps:
1. Connect the CP blades to the LAN:
a. Insert the Ethernet cables into each Ethernet port.
b. Connect the other end of the cables to an Ethernet 10/100 Base-T LAN, if not already
connected.
IMPORTANT: The DC SAN Director can be accessed by remote connection using any
of the available management tools, such as Telnet or WebTools. Ensure that the DC SAN
Director is not modified using other connections during the rest of this procedure.
Replacing the DC SAN Director chassis 91