HP DC SAN Backbone Director Switch Hardware Reference Guide (5697-2158, August 2012)

2. Reconnect the transceivers and cables to the port blades.
NOTE: The ports and cables used in trunking groups must meet specific requirements. For
a list of these requirements, see the Fabric OS Administrator's Guide.
a. Position one of the transceivers so that the key is oriented correctly to the port and insert
the transceiver into the port until it is firmly seated and the latching mechanism clicks.
b. Select the cable that corresponds to the port and position it so that the key (the ridge on
one side of the cable connector) is aligned with the slot in the transceiver; then, insert the
cable into the transceiver until the latching mechanism clicks.
c. Repeat step 2a and step 2b for the remaining ports.
TIP: Do not route cables in front of the air exhaust vent (located on the upper port side
of the chassis).
d. Organize the cables as required.
92 Replacing DC SAN Director FRUs