Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 93

53-1002167-01

SAN End node display

The connectivity map can be configured to display or not display end nodes. This option enables

you to set the end node display for all newly discovered fabrics. Note that disabling end node

display limits the connectivity map to emphasize switch members only.

Displaying end nodes

To display end nodes when discovering a new fabric, complete the following steps.

1. Select Server > Options.

The Options dialog box displays (Figure 36).

FIGURE 36 Options dialog box (SAN End Node Display option)

2. Select SAN End Node Display in the Category list.

3. Select the Show connected end nodes when new fabric is discovered check box to display end

nodes on your system.

NOTE

Before changes can take effect, the topology must be rediscovered.

4. Click Apply or OK to save your work.