Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 221
53-1002167-01
AAA Settings
9
3. Click Add.
The Add or Edit LDAP Server dialog box displays (Figure 78).
FIGURE 78 Add or Edit LDAP server
4. Enter the LDAP server’s IP address in the IP Address field.
5. Enter the TCP port used by the LDAP server in the TCP Port field.
Default is 389.
6. Enter the timeout timer value (in seconds) that specifies the amount of time to wait between
retries when the server is busy in the Timeout (Sec) field.
Default is 3 seconds.
7. Enter the number of attempts to be made to reach a server before assuming it is unreachable
in the Attempts field.
Default is 3 attempts.
8. Click OK to return to the AAA Settings tab.
9. If you have established an active connection with the LDAP server, click Test.
Test attempts to contact the LDAP server by issuing a ping command.
10. Set secondary authentication by selecting one of the following options from the Secondary
Authentication list:
• Local Database
• None
11. Set the fall back condition to secondary authentication by selecting one of the following
options from the Switch to secondary authentication when list:
• LDAP Servers Not Reachable
• LDAP Authentication Failed
• User Not Found in LDAP
12. Set the authorization preference by selecting one of the following options from the
Authorization Preference list:
• Local Database
• Primary Authentication Server
• LDAP Authorization
13. Click Apply to save the configuration.