Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 223
53-1002167-01
AAA Settings
9
9. Click OK to return to the AAA Settings tab.
10. Set secondary authentication by selecting one of the following options from the Secondary
Authentication list:
• Local Database
• None
11. Set the fall back condition to secondary authentication by selecting one of the following
options from the Fail Over Option list:
• TACACS+ Server Not Reachable
• TACACS+ Server Authentication Failed
12. Set the authorization preference by selecting one of the following options from the
Authorization Preference list:
• Local Database
• Primary Authentication Server
13. Click Test.
The Test Authentication dialog box displays.
14. Enter your user ID and password and click Test.
Test verifies your user ID and password for the local database and verifies user privileges on
the Management application server.
15. Click Apply to save the configuration.
Configuring switch authentication
Switch authentication enables you to authenticate a user account against the switch database and
the Management application server. You can configure up to three switches and specify the fall
back order if one or more of the switches is not available.
NOTE
Switch authentication is only supported on Fabric OS devices.
To configure switch authentication, complete the following steps.
1. Select the AAA Settings tab.
2. For Primary Authentication, select Switch.
3. Enter the switch IP address and click Add.
Repeat step 3 as needed. You can add up to three switches.
4. Set up the fall back order by completing the following steps.
a. Select the IP address of the switch you want to move.
b. Click Move Up or Move Down to move the switch where you want it.
5. Select a switch and click Remove to remove a switch from the list.
6. Click Test.
The Test Authentication dialog box displays.