Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

342 Brocade Network Advisor SAN User Manual
53-1002167-01
Switch policies
14
Configuring the DCB interface with the DCB Map and Global LLDP profile
To configure the DCB interface, complete the following steps.
1. Select Configure > DCB.
The DCB Configuration dialog box displays.
2. Select the Te port connected to the CNA in the DCB Ports and LAGs table and click Edit.
3. Select the Port tab, if necessary, and select the Enable check box.
4. Select L2 from the Interface Mode list.
5. Select Converged (for a Brocade CNA) or Access (for QLogic CNA) from the L2 Mode list.
6. Click the QOS tab and select the Assign a map check box.
7. Sel ec t DCB from the Map Type list.
8. Select the DCB map you created in “Creating a DCB map to carry the LAN and SAN traffic” on
page 340 from the Available DCB Maps list.
9. Click the LLDP-DCBX tab and select the Enable LLDP-DCBX on Te Port Number check box.
10. Select Assign the Global Configuration.
11. Click OK.
The Deploy to Ports dialog box displays.
12. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box launches.
13. Click Start on the Deployment Status dialog box to save the changes to the selected ports.
14. Click Close to close the Deployment Status dialog box.
Create the FCoE VLAN to carry FCoE traffic
NOTE
This procedure is completed using Web Tools.
To create the FCoE VLAN, complete the following steps. This procedure is applicable for FOS
versions lower than FOS 7.0.
1. Select the Fabric OS FCoE switch in the Product Tree or Connectivity Map.
2. Select Configure > Element Manager > Admin.
Web Tools displays. You can also launch Web Tools by clicking the Element Manager button on
the DCB Configuration dialog box.
3. Click the DCB tab.
4. Click the VLAN tab.
5. Click Add.
The VLAN Configuration dialog box displays.
6. Enter the VLAN identifier in the VLAN ID field.