Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 351

53-1002167-01

Switch policies

Enabling a DCB port or LAG

If you select multiple switches or multiple ports and LAGs from two or more switches, both the

Enable button and the Disable button are disabled.

1. Select Configure > DCB from the menu bar.

The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and

functions.

2. Select one or more DCB ports or LAGs (which can span multiple switches) that you want to

enable.

NOTE

All selected LAGs must be in the same state (enabled or disabled); otherwise, both the Enable

and Disable buttons are disabled.

3. Click Enable.

The Confirmation and Status dialog box launches with the selected Ports or LAGs.

4. Click Start on the Confirmation and Status dialog box to save the changes to the selected ports

or LAGs.

The selected DCB ports or LAGs are enabled in the DCB Configuration dialog box.

5. Click Close to close the Confirmation and Status dialog box.

Deleting a LAG

You can only delete a link aggregation group (LAG) that is selected from a single switch. If you select

multiple switches or multiple ports from two or more switches, the Delete button is disabled.

1. Select Configure > DCB from the menu bar.

The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and

functions.

2. Select one or more LAGs (that can span multiple switches) that you want to delete from the

Products/Ports table.

3. Click Delete.

The Confirmation and Status dialog box launches with the selected LAGs.

4. Click Start on the Confirmation and Status dialog box to save the changes to the DCB switches.

The selected LAGs are deleted in the DCB Configuration dialog box.

5. Click Close to close the Confirmation and Status dialog box.