Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 363
53-1002167-01
VLAN classifier configuration
14
FIGURE 129 Edit Switch dialog box, VLAN Classifiers tab
4. Click the Add button under the Available Rule list.
The Add Rules dialog box displays, as shown in Figure 130.
FIGURE 130 Add Rules dialog box
The Rule ID field is pre-populated with the next available Rule ID number.
5. Keep the Rule ID number as it is, or change the number using a value between 1 through 256.
6. Select a rule type. Valid rule types are MAC (MAC address-based rule) and Proto (802.1Q
protocol-based rule).
7. If Ethernet Type is selected as the Protocol rule type, enter any valid four-digit hexadecimal
value within the allowed range of 0x0000 through 0xFFFF. For the other Proto options, the hex
ID value is hard-coded as follows:
• ARP—0x0808
• IP—0x8881
• IPv6—0x86DD
8. Select an encapsulation type from the list. Options include Ethv2, nosnapllc, and snapllc.
Encap only accepts a value when Protocol is selected as the rule type.