Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 367
53-1002167-01
LLDP-DCBX configuration
14
FIGURE 131 Edit Switch dialog box - LLDP-DCBX tab
5. Select the Global Configuration LLDP profile in the LLDP Profiles table.
6. Click the left arrow button to edit.
7. Select the FCoE Application and FCoE Logical Link check boxes in the Advertise table to
advertise them on the network.
8. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box, shown in Figure 134.
Adding an LLDP profile
NOTE
When a TE port is selected to assign to an LLDP profile, a yellow banner displays with the following
error message: “LLDP-DCBX is disabled on this switch. The configuration becomes functional when
LLDP-DCBX is enabled on the switch.”
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a switch, and click Edit.
3. Click the LLDP-DCBX tab on the Edit Switch dialog box.
The LLDP-DCBX dialog box displays.
4. Click the Enable LLDP-DCBX checkbox.