Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 487
53-1002167-01
Creating a new encryption group
18
All configuration items have green check marks if the configuration is successful. A red stop
sign indicates a failed step. A message displays below the table, indicating the encryption
switch was added to the group you named, and the public key certificate is stored in the
location you specified.
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See “Understanding configuration status
results” on page 503 for more information.
10. Verify the information, then click Next.
The Next Steps dialog box displays (Figure 192). Instructions for installing public key
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
FIGURE 192 Next Steps dialog box
11. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
12. Click Finish to exit the Configure Switch Encryption wizard.
Configuring key vault settings for HP Secure Key Manager (SKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to “Creating a new encryption group”
on page 474.
Figure 193 shows the key vault selection dialog box for SKM.