Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

504 Brocade Network Advisor SAN User Manual
53-1002167-01
Adding a switch to an encryption group
18
Adding a switch to an encryption group
The setup wizard allows you to either create a new encryption group, or add an encryption switch to
an existing encryption group. Use the following procedure to add a switch to an encryption group:
1. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays (Figure 153).
2. Select a switch to add from the Encryption Center Devices table, then select Switch >
Create/Add to Group from the menu task bar, or right-click a switch and select Create/Add to
Group.
NOTE
The switch must not already be in an encryption group.
The Configure Switch Encryption wizard welcome panel displays (step 213).
FIGURE 213 Configure Switch Encryption wizard - welcome panel
3. Click Next.
The Designate Switch Membership dialog box displays (Figure 214).