Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 513

53-1002167-01

Adding encryption targets

Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators

within the encryption switch.

NOTE

It is recommended that you configure the host and target in the same zone before configuring them

for encryption. If the host and target are not already in the same zone, you can still configure them

for encryption, but you will need to configure them in the same zone before you can commit the

changes. If you attempt to close the Encryption Targets dialog box without committing the changes,

you are reminded of uncommitted changes in the Management application.

1. Select Configure > Encryption from the menu task bar.

The Encryption Center dialog box displays (Figure 153).

2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the

target, then select Group/Switch/Engine > Targets from the menu task bar, or right-click a

group, switch, or engine and select Targets.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays (Figure 222).

FIGURE 222 Encryption Targets dialog box

3. Click Add.

The Configure Storage Encryption wizard dialog box displays. The dialog box explains the

wizard’s purpose, which is to configure encryption for a storage device (target).