Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

522 Brocade Network Advisor SAN User Manual
53-1002167-01
Adding target disk LUNs for encryption
18
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard. To launch the wizard, complete the following steps:
Before You Begin
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays.
For more information, see “Configuring Storage Arrays” on page 525.
1. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays (Figure 153).
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Disk LUNs from the menu task bar, or right-click a group, switch, or
engine and select Disk LUNs.
The Encryption Disk LUN View dialog box displays (Figure 233).
FIGURE 233 Encryption Disk LUN View dialog box
3. Click Add.
The Select Target Port dialog box displays (Figure 234).
FIGURE 234 Select Target Port dialog box