Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

524 Brocade Network Advisor SAN User Manual

53-1002167-01

Adding target disk LUNs for encryption

FIGURE 236 Select LUN dialog box

8. Set the Current LUN State as required. If the LUN already has an existing key ID, the Current

LUN State field is automatically set to Encrypted. You can accept the automatically assigned

state or change this value if desired.

9. If REPL Support was enabled by the Configure Switch Encryption wizard, a New LUN check box

is presented and enabled by default. If this LUN is to be paired with another LUN for SRDF data

replication, the New LUN option must be enabled by selecting this check box. Refer to

“Metadata requirements and remote replication” for information about how this option works.

If REPL support was not enabled, this check box is not displayed.

10. Click Finish.

The new LUN path is added to the Encryption Disk LUN View table.

11. In environments where there are multiple paths to the same LUNs, it is critical that the same

LUN policies are configured on all instances of the LUN. Be sure to return to the Encryption

Disk LUN View dialog box to determine if there are configuration mismatches. Check under

Encryption Mode for any entries showing Mismatch. To correct the mismatch, click the

incorrect mode to display the options, then select the correct mode (Figure 237).