Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 529

53-1002167-01

Adding target tape LUNs for encryption

You configure a Crypto LUN by adding the LUN to the CryptoTarget container and enabling the

encryption property on the Crypto LUN. You must add LUNs manually. After you add the LUNs, you

must specify the encryption settings.

When configuring a LUN with multiple paths, the same LUN policies must be configured on all

paths to the LUN. If there are multiple paths to the same physical LUNs, then the LUNs are added

to multiple target containers (one target per storage device port).

1. Select Configure > Encryption from the menu task bar.

The Encryption Center dialog box displays (Figure 153).

2. Select a group, switch, or engine from the Encryption Center Devices table that contains the

storage device to be configured, then select Group/Switch/Engine > Targets from the menu

task bar, or right-click a group, switch, or engine and select Targets.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays (Figure 239).

FIGURE 239 Encryption Targets dialog box

3. Select a target tape storage device from the Encryption Targets table, then click LUNs.

The Encr yption Target Tape LUNs dialog box displays (Figure 240).