Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 561

53-1002167-01

Viewing and editing switch encryption properties

To view switch encryption properties, complete the following steps:

1. Select Configure > Encryption from the menu task bar.

The Encryption Center dialog box displays (Figure 153). The dialog box shows the status of all

encryption-related hardware and functions at a glance. It is the single launching point for all

encryption-related configuration.

2. Select a switch or encryption engine from the Encryption Center Devices table, then select

Switch/Engine > Properties from the menu task bar, or right-click a switch or encryption engine

and select Properties.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Properties dialog box displays (Figure 266).

FIGURE 266 Encryption Properties dialog box

The dialog box contains the following information:

• Switch Properties table - the properties associated with the selected switch.

• Name - the name of the selected switch.

• Node WWN - the world wide name of the node.