Manualshelf

Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

ManualsBrandsHP ManualsSoftwareHP B-series SAN Network Advisor Software
651652653654655656657658659660
Brocade Network Advisor SAN User Manual 611
53-1002167-01
Traffic isolation zoning
19
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click the traffic isolation zone you want to disable in the Zones list and clear the
Configured Enabled check box.
5. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas. The traffic isolation zone is not disabled until you activate a zone
configuration in the same zone database.
Enabling failover on a traffic isolation zone
NOTE
Traffic isolation zones are configurable only on a Fabric OS device.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click the traffic isolation zone you want to enable failover on in the Zones list and select
Configured Failover.
5. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
Disabling failover on a traffic isolation zone
NOTE
Traffic isolation zones are configurable only on a Fabric OS device.
If failover is disabled, be aware of the following considerations:
• Ensure that there are non-dedicated paths through the fabric for all devices that are not in a TI
zone.
• If you create a TI zone with just E_Ports, failover must be enabled. If failover is disabled, the
specified ISLs will not be able to route any traffic.