Manualshelf

Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

ManualsBrandsHP ManualsSoftwareHP B-series SAN Network Advisor Software
661662663664665666667668669670
622 Brocade Network Advisor SAN User Manual
53-1002167-01
Zoning administration
19
4. Select the zone member in the Zones list that you want to find in the Potential Members list.
Press SHIFT or CTRL and click each zone to select more than one zone.
5. Click Find < between the Potential Members list and the Zones list.
• If the member is found, it is highlighted in the Potential Members list.
• If the member is not found, a message displays informing you of this. Click OK to close the
message box.
• If there are no ports listed in the Potential Members list, a message displays informing you
that additional action is required. Right-click within the list panel and select Port Display
from the shortcut menu to display ports.
Finding zones in a zone configuration
Use this procedure to locate all instances of a zone in the Zone Configurations list on the Zone DB
tab.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Select the zone you want to find in the Zones list.
Press SHIFT or CTRL and click each zone to select more than one zone.
5. Click Find > between the Zones list and the Zone Configurations list.
• If the zone is found, all instances of the zone are highlighted in the Zone Configurations
list.
• If the zone is not found, a message displays informing you of this. Click OK to close the
message box.
Finding a zone configuration member in the zones list
Use this procedure to locate a zone configuration member in the Zones list on the Zone DB tab.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Select the zone configuration member (i.e., the zone) in the Zone Configurations list that you
want to find in the Zones list.
Press SHIFT or CTRL and click each zone to select more than one zone.