Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 731
53-1002167-01
Port VLANs
24
FIGURE 335 Select Classifier Groups dialog box
Adding or modifying dual-mode ports
You can configure an interface in a VLAN as a dual-mode port by assigning it as a tagged port to
one VLAN and as an untagged port to another VLAN. You can add a dual-mode port to any VLAN
except the default VLAN, VLAN 1.
To add a dual-mode port to a VLAN, perform the following steps.
1. Read the steps in the section “Adding or modifying Port VLANs” on page 729 to familiarize
yourself with adding tagged and untagged ports to a VLAN.
2. From the Available Ports list on the Port VLAN Configuration dialog box, select the interface
that will be added as a dual-mode port.
3. Select a VLAN from the Select VLANs list.
4. Click the Untag >> button to assign the port as an untagged port into the selected VLAN. The
Selected Ports list shows the interface listed under the VLAN to which it was assigned.
5. Select the same interface from the Available Ports list.
6. Select another VLAN from the Select VLANs list.
7. Cli c k t h e Tag >> button to assign it as a tagged port to the second VLAN. The Selected Ports list
shows the port as untagged under one VLAN and tagged under another VLAN.