Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 773
53-1002167-01
View All list troubleshooting
26
View All list troubleshooting
The following section states a possible issue and the recommended solution for View All list errors.
Zoning troubleshooting
The following section states some possible issues and recommended solutions for zoning errors.
Problem Resolution
View All list does not display. The View All list does not display until you discover a fabric. To discover a fabric, refer to
“Discovering fabrics” on page 49.
View All list does not display and there are
discovered fabrics.
Example
If you create a new view ’V1’ that has one
fabric ‘F1’ and you display the new view in the
SAN tab (select V1 from the View All list). Then
you delete the fabric F1 from Discovery, the
View All list no longer displays and the following
messages displays:
View loaded, no devices present in the current
view. Refer to the Troubleshooting Guide in
Help (F1) for assistance.
To select another view, select View > Manage View > Display View > View_Name.
Problem Resolution
Cannot perform zoning on a new switch. You must use telnet (or the Product Type and Access tab in the Add Properties dialog box)
to change the default password on the new switch before you can use the Management
application to perform zoning.
When configuring a large zone configuration a
switch displays offline during discovery.
If a large zone configuration is configured in a fabric, switches may temporarily display as
being offline during discovery.
Wait for the next discovery cycle and click the Refresh button on the toolbar.
When activating a large zone configuration on
a two-switch fabric on UNIX platforms, an error
message displays stating “Failed to perform
the requested zoning action: Failed to zone due
to exception.”
Although the error message states that the requested zoning action failed, the zone
configuration will be correctly activated. Wait for the next zoning polling to occur.
This issue only occurs on UNIX systems.
Zoning activation message displays for a long
time, but zone configuration is not activated.
Telnet zoning can take a long time. To improve speed, open the Discover Setup dialog box
(Discover > Setup) and add the IP address for the device to the Selected Individual
Addresses list.
Out of memory error caused by running a
zoning report for a large zone configuration
(1 MB) in a medium-sized SAN due to a third
party tool.
You must increase the client memory allocation by completing “Configuring memory
allocation settings” on page 119.