Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 781
53-1002167-01
SAN performance overview
27
4. Click the Manual option to view SNMP credentials.
5. Click the SNMP tab.
6. Select the v1 or v3 from the SNMP Version list.
7. Make sure SNMP credentials match those on the device.
8. Click OK on the AddFabric Discovery dialog box.
9. Click Close on the Discover Fabrics dialog box.
- To set SNMP credentials in the Management application, refer to “Discovery” on page 47.
• Make sure that the SNMP security level is set to the appropriate level for the switch.
- To check the SNMP security level, use the snmpconfig --show secLevel command.
Example of checking SNMP security level
snmpconfig --show secLevel
GET security level = 0, SET level = 0
SNMP GET Security Level: No security
SNMP SET Security Level: No security
- To set the SNMP security level, use the snmpconfig --set secLevel command.
Example of checking SNMP security level
snmpconfig --set secLevel 0
Select SNMP GET Security Level
(0 = No security, 1 = Authentication only, 2 = Authentication and Privacy,
3 = No Access): (0..3) [0]
• To collect performance for GigE ports and FCIP statistics, make sure that SNMP v3 credentials
match (see above) and that FCIP-MIB capability is enabled.
- To check FCIP-MIB capability, use the snmpconfig --show mibcapability command.
Example of showing FCIP-MIB
FCRRouter:admin> snmpconfig --show mibcapability
FCIP-MIB: YES
- To enable FCIP-MIB capability, use the snmpconfig --set mibcapability command.
Example of enabling FCIP-MIB
FCRRouter:admin> snmpconfig --set mibcapability
FA-MIB (yes, y, no, n): [yes]
FICON-MIB (yes, y, no, n): [yes]
HA-MIB (yes, y, no, n): [yes]
FCIP-MIB (yes, y, no, n): [yes]
ISCSI-MIB (yes, y, no, n): [yes]