Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

850 Brocade Network Advisor SAN User Manual
53-1002167-01
SNMP traps
30
FIGURE 372 SNMP Trap Recipients dialog box
2. Click Add from the Action list.
3. Enter the IP address of the SNMP trap receiver (the recipient server) in the Recipient IP
Address field. This is a mandatory field. IPv4 addresses are accepted, but a Domain Name
System (DNS) name is not accepted.
4. Enter the SNMP trap port of the recipient in the Recipient Port field. This is a mandatory field.
Valid numeric values range from 1 through 65535 and 162 is the default.
5. Select the fabric or switches from the Available list and click the right arrow button to move it to
the Selected list. You can select multiple products.
NOTE
For IP products and product groups, only switches are available to select.
6. If the selected product is a SAN fabric, select a severity from the Severity list. Severity levels
can be one of the following: None, Critical, Error, Warning, Info, or Debug. The Severity list is
disabled for IP products (None is the default).
7. Cli c k t h e View Recipients button to list the recipients that correspond to a selected fabric or
product from the Available list.
The Trap Recipients - Fabric dialog box or the Trap Recipients - IP address dialog box
(depending on which product you selected), displays a list of configured recipients.
8. Click OK.
The Management application registers the recipient IP address as an SNMP trap recipient. The
SNMP version and credentials from the SNMP profile (for example, SNMP v3) are registered.