Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

854 Brocade Network Advisor SAN User Manual
53-1002167-01
SNMP traps
30
Adding a new trap filter
The Add Trap Filter dialog box allows you to configure trap filters for forwarding SNMP traps. You
can add trap filters on SAN products, IP products, or Hosts.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box displays.
2. Click Add in the Trap Filters area of the SNMP Trap Forwarding dialog box.
The Add Trap Filter dialog box, shown in Figure 375, displays.
FIGURE 375 Add Trap Filter dialog box
3. Select the SAN, IP, or Host tab. Depending on the tab selected, the products available to which
you can add a trap filter display in the Available Products list.
4. Enter a unique name for the trap filter in the Filter Name field.
5. Enter a general description of the trap filter in the Description field.
6. Click the Forward Application Messages check box to forward application events.
7. Cli c k t h e Forward pseudo events check box to forward pseudo events.
8. Select a severity level from the Severity list. The severity level can be one of the following, and
appear in descending order of severity.
• Emergency
• Alert
• Critical
• Error