Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

860 Brocade Network Advisor SAN User Manual

53-1002167-01

SNMP traps

4. Save the file.

The Management application recompiles all the MIB files. If compilation is successful, the

traps can now be registered in the Event Reception dialog box.

NOTE

If there are compilation errors, you can view the errors in the server log

<install dir>\logs\server\server.log (Windows) or <install dir>/logs/server/server.log (UNIX).

5. If you make changes to the MIB file, open the mibs_to_compile.txt file and save the file.

The Management application recompiles the MIB files and reloads the changes.

Trap customization

The Trap Configuration tab of the Event Reception dialog box enables you to configure the following

settings:

• Register and unregister traps of various management information bases (MIBs)

• Customize trap description messages based on varbinds and severity and specify alias names.

Registering traps

Traps must be registered in the Event Reception dialog box to make them available. Perform the

following steps to register traps.

1. Select Monitor > SNMP Setup > Event Reception.

2. Click the Trap Configuration tab.

The Trap Configuration tab of the Event Reception dialog box, shown in Figure 379, displays.

The Registered and Not Registered buttons at the top of the Traps tree serves as a filter for the

traps. If there are unregistered traps, they are listed when you select the Not Registered

button.

Traps appear under each MIB folder. The MIB folders correspond to the MIBs identified in the

mibs_to_compile.txt file.