Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 869
53-1002167-01
Event action definitions
30
11. Select Configure varbind filters to configure filters on varbind values (see “Configuring varbind
filters” on page 869 for more information). If you do not want to configure varbind filters, click
Next.
The Sources pane of the Add Event Action dialog box is displayed. You can use the search tool
to search for sources.
Configuring varbind filters
If actions must be confirmed based on a trap variable binding value (varbinds), select the varbind
filters check box on the Events pane of the Add Event Action dialog box. This enables you to
configure filters on varbind values for this event action.
NOTE
Varbind filter configuration is only available if you selected Traps in step 5 of “Creating an event
action definition” on page 867.
The varbinds for the selected trap are listed in the Available Varbinds list, shown in Figure 386.
1. Select Monitor > Event Processing > Event Actions.
The Event Actions dialog box displays.
2. Click Next to advance to the Events pane.
FIGURE 386 Available varbinds and Selected varbinds dialog box
3. Select the varbind you want to include in the configuration and click the right arrow button to
move it to the Selected Varbinds list.
If you selected more than one trap and those traps have the same varbinds, then their
varbinds are listed in the Available Varbinds box. However, if the traps you selected have
different varbinds, the Available Varbinds box is empty.
4. For each varbind in the Selected Varbinds list, select one of the following operations for the
condition you want to filter:
• = – Equal to
• != – Not equal
• < – Less than
• > – Greater than
• >= – Greater than or equal to
• <= – Less than or equal to