Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

144 DCFM Enterprise User Manual
53-1001357-01
Removing an option from a device’s shortcut menu
3
9. Select the tool from the Tool list that you want to launch, or click Define to add a tool.
To specify a new tool, refer to “Adding a tool” on page 138.
10. Select the Append device ID check box to specify the parameter used when opening the tool.
- To specify that the device’s IP address should be used when opening the tool, select the IP
Address option.
- To specify that the device’s Node WWN should be used when opening the tool, select the
Node WWN option.
11. Click Edit.
NOTE
You must click Edit before clicking OK; otherwise, your changes will be lost.
12. Click OK to save your work and close the Setup Tools dialog box.
Removing an option from a device’s shortcut menu
You can remove a tool that displays on a device’s shortcut menu.
To remove an option to the device’s shortcut menu, complete the following steps.
1. Select Tools > Setup.
The Setup Tools dialog box displays.
2. Click the Product Menu tab.
The Product Popup Menu Items table displays all configured menu options.
3. Select the menu item you want to remove in the Product Popup Menu Items table.
4. Click Remove.
5. Click OK to save your work and close the Setup Tools dialog box.
Starting third-party tools from the application
You can open third-party tools from the Tools menu or a device’s shortcut menu. Remember that
you cannot open a tool that is not installed on your computer. You must install the tool on your
computer and add the tool to the Tools menu or the device’s shortcut menu.
To open an application, perform the following steps.
1. Select the device.
2. Use one of the following techniques:
• Select Tools > Product Menu > <Tool_Name>.
• Select Tools > <Tool_Name>.
• Right-click the device, and select the tool from the menu.
If the third-party tool is a web-based application, you must enter the IP address of the
applications server as a parameter to be able to open the application. For step-by-step
instructions about entering the IP address of the server, refer to “Entering the server IP
address of a tool” on page 139.