Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 289
53-1001357-01
Adding an SNMPv3 destination
7
4. Click Add.
The Add/Edit Trap Recipient dialog box displays.
a. (Optional) In the Description field, enter a description of the trap recipient.
b. In the IP Address field, enter the trap recipient’s IP address.
The Management application accepts IP addresses in IPv4 or IPv6 formats.
c. Enter the trap recipient’s UDP port number, in the port field.
d. Click OK on the Add/Edit Trap Recipient dialog box.
5. Click OK on the SNMP Setup dialog box.
Adding an SNMPv3 destination
You can only configure six destinations, including v1 and v3 destinations.
To add a V3 destination, complete the following steps.
1. Select Monitor > SNMP Setup.
The SNMP Setup dialog box displays.
2. Click the Trap Forwarding tab.
3. Select V3 from the Trap forwarding type list.
4. Enter a user name in the User Name field.
5. (Optional) Enter a context name in the Context Name field.
6. Select the authorization protocol in the Auth Protocol field.
7. Enter the authorization password in the Auth Password field and the Retype Password field.
8. Select the privacy protocol in the Priv Protocol field.
9. Enter the privacy password in the Priv Password field and the Retype Password field.
10. Click Add.
The Add/Edit Trap Recipient dialog box displays.
a. (Optional) In the Description field, enter a description of the trap recipient.
b. In the IP Address field, enter the trap recipient’s IP address.
The Management application accepts IP addresses in IPv4 or IPv6 formats.
c. Enter the trap recipient’s UDP port number, in the port field.
d. Click OK on the Add/Edit Trap Recipient dialog box.
11. Click OK on the SNMP Setup dialog box.