Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 303
53-1001357-01
Real-time performance data
8
• To collect performance on a Virtual Fabric enabled device, use the admin> userconfig
--show
command to make sure the Fabric OS user has access to all the Virtual Fabrics. Make
sure that the SNMPv3 user name is same as the Fabric OS user name. Otherwise, the data is
not collected for virtual switches with a non-default VF ID. By default the
admin user has
access to all Virtual Fabrics.
Example of Fabric OS user verification
sw1:FID128:admin> userconfig --show
Account name: admin
Description: Administrator
Enabled: Yes
Password Last Change Date: Unknown
Password Expiration Date: Not Applicable
Locked: No
Home LF Role: admin
Role-LF List: admin: 1-128
Chassis Role: admin
Home LF: 128
- Make sure I/O is running on the switch to obtain real statistics. To view switch statistics,
use the
portperfshow <interval> (FC Ports) or portshow fciptunnel <Ge port
number> <tunnel no> -perf
(FCIP tunnels) command.
Example for FC ports
Sprint-65:root> portperfshow 5
Example for FCIP tunnels
Sprint-65:root> portshow fciptunnel ge0 1 -perf
Real-time performance data
Real-time performance enables you to collect data from managed devices in your SAN. Real-time
performance is only supported on the following managed objects: FC (E_ and F_ports), GE_ports,
10GE_ports, Managed HBA Ports, and FCIP tunnels. You can use real-time performance to
configure the following options:
• Select the polling rate from 10 seconds up to 1 minute.
• Select up to 32 ports total from a maximum of 10 devices for graphing performance.
NOTE
Virtual Fabric logical ISL ports are not included in performance collection.
• Choose to display the same Y-axis range for both the Tx MB/Sec and Rx MB/Sec measure
types for easier comparison of graphs.