Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 405
53-1001357-01
Link aggregation groups
13
6. Continue to configure the following LAG parameters. These parameters are disabled until you
add a CEE port to the LAG members table.
• Mode - Sets all ports added to the LAG members table in either Static or Dynamic mode.
The default is Dynamic, Active, but LAG members can be Active or Passive if the LAG
member is Dynamic.
• Type - Sets the limit on the size of the LAG. The type values include Standard, where the
LAG is limited to 16 ports, and Brocade, where the LAG is limited to four ports. The default
is Standard.
NOTE
The 8 Gbps 16-FC-ports, 10 GbE 8-Ethernet Port has three anvil chips and each anvil chip
supports eight 10 Gbps Ethernet ports. You cannot create Brocade-type LAGs from
different anvil chips. If you do, an error message displays and only the first port is
considered as part of the LAG.
7. When you have finished configuring the policies, click OK.
The CEE Confirmation and Status dialog box displays.
8. Review the changes carefully before you accept them.
9. Click Start to apply the changes, or click Close to abort the operation.
If the operation was successful, the new LAG displays in the custom products list in the CEE
Configuration dialog.